Polaris ACE Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a 18 900 xc , few issues ....
Firstly the machine has lost Speedo , even after replacing 2 speed sensors... Ive lost eps due to that...
Secondly is there a prop shaft upgrade for these machines ? Ive replaced 2 due to u joints going bad. (Very little mud/water) now the yolk on both ends have a lot of slop in them. Splines on trans seem fine and same with front diff.
Third can not seem to find the metal bushings for upper front a arms.(metal with o ring)
Little info about my machine. 2018 900 xc silver peral. 6243 miles 312 hours. Bone stock except for tires and wheels. (30/10/14 Rocktanes )
Only issues ive had were 1 prop shaft , 1 primary clutch and a lot of brake pads lol. Just replaced rack and pinion from rackzilla. And today I finally changed stock belt lol.
 

·
Registered
Joined
·
3 Posts
I work for a driveline shop (Minnesota Driveline Inc). When we replace the u joints on the polaris prop shafts and balance them, we recommend greasing the u joints often and getting the shaft balanced. That should help am lot.
 
1 - 2 of 2 Posts
Top