Polaris ACE Forum banner
1 - 2 of 2 Posts

· Registered
65 Posts
Discussion Starter · #1 ·
Hi, I have had an issue with the Ace overheating and haven't ridden it in a long time. So, now I'm trying to tackle it once again.

All I think I'm left with is either the valve adjustment is too tight or I have a blown head gasket

The compression was around 60psi if I remember correctly. Anyway, could someone send me the directions on how to check the valve lash on these please? If this checks well Im going to have to figure out how to pull the head. At this time I don't have a manual.
Thanks for any help!
1 - 2 of 2 Posts