Polaris ACE Forum banner

floor pan

1101 Views 1 Reply 2 Participants Last post by  Scoundrel
I am going to run wires for turn signals on Sunday. Has anyone pulled the floor pan for anything else? If so are there just screws & simple remove, or is it an issue. Want to run wires in conduit & attach away from drive shaft, so i think I need in there.

Thanks
Doug
1 - 2 of 2 Posts
I ran my signal wiring without pulling the floor panel. Didn't seem like I needed to. But some of my wiring might be a little more exposed than you'd like, maybe.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top