[almosthere]

2014 325 ace.when i turn on key the fuel pump comes on but no lights on dash and no crank.tried jumping brake switch,checked relays,new ign switch,battery is good even put jumper on just in case.have run out of things to try, someone please give me some ideas to try.thanks for any help john

 

[mayer7196]

2014 325 ace.when i turn on key the fuel pump comes on but no lights on dash and no crank.tried jumping brake switch,checked relays,new ign switch,battery is good even put jumper on just in case.have run out of things to try, someone please give me some ideas to try.thanks for any help john

You tried everything I would have.Maybe voltage regulator?

Question though-----where is the brake switch located? I am having an issue with it.

 

[almosthere]

You tried everything I would have.Maybe voltage regulator?

Question though-----where is the brake switch located? I am having an issue with it.

over right front tire,you will see 2 wires coming out of it

 

[tunacan32]

2014 325 ace.when i turn on key the fuel pump comes on but no lights on dash and no crank.tried jumping brake switch,checked relays,new ign switch,battery is good even put jumper on just in case.have run out of things to try, someone please give me some ideas to try.thanks for any help john

Did you check all of the fuses? When you get it figured out please let us know what the problem was ok

 

[almosthere]

Did you check all of the fuses? When you get it figured out please let us know what the problem was ok

it was buss bar under the hood next to the radiator sitting on top.they were loose.worked at shop every time until mechanic moved wires along frame rail it stoped working.cleaned and put back on with dielectric grease runs great

 

[mayer7196]

over right front tire,you will see 2 wires coming out of it

I just be blind, I see nothing LOL

 

[almosthere]

I just be blind, I see nothing LOL

they are coming out of the master cylinder,look under the hood and see that then follow it under to see the 2 wires pluged into it

 

[mayer7196]

they are coming out of the master cylinder,look under the hood and see that then follow it under to see the 2 wires pluged into it

If i were to buy a new one, how hard is it to do? does it just pop on and off?

 

[almosthere]

the wires yes the master cylinder not so much,as there is 3 break lines piggy backed on it with washer gaskets between each one.not a lot of room to get your hand in there.look in the polaris site and there is a drawing with part numbers

 

[doubledoug15]

the wires yes the master cylinder not so much,as there is 3 break lines piggy backed on it with washer gaskets between each one.not a lot of room to get your hand in there.look in the polaris site and there is a drawing with part numbers