Polaris ACE Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter #1
assuming someone has them, just wondering what differences you noticed between stock tires & big horn 2 is same 25" sizes. I have a set of RZR black chrusher wheels so outside should stay under 50" so probably wont make it any less tippy. I don't see the big horn 2 being much heavier (wheels are light too) but definitely more square in rear. I have had good luck with the big horn 2 on grizzly before, so leaning that way to replace the stockers. Any thoughts?
 

·
Registered
Joined
·
93 Posts
Funny, I just put deposit down today on ace and ordered 26x9 bighorn 2.0 all the way around with those very same rims. Im very concerned with staying under 50 in. If you went this route you would need two more front rims though. Guess I can get you pictures next weekend.
 

·
Registered
Joined
·
34 Posts
Discussion Starter #3
I saw one with a set of 26" big horn regular takeoffs (wider rear) & they were still under 50" & most of wide rear was to inside. They did get minor rubbing when turning on the front. That is why I was thinking about 25"

I have the stock tires on (4) front black chrushes and the rear tires seem very rounded. You won't have that issue with all 9" big horns as they are flatter. I put 4 mongrel 26 x 9 x 12 on all fronts & I had to add 1" spacers on the front to clear the tire to the strut. Way too heavy for unit & were hard to turn. I did not need spacer for the stock wheels on the same wheels.

also note that the front wheels on the rear measure wider than same tire on rear wheels on the back even though the fronts are narrower.
 
1 - 4 of 4 Posts
Top